BT Freestyle 70 Bedienungsanleitung

User Guide F r eest yle 70 This equipment is not designed for making emergency telephone calls when the power fails. Alternative arrangements should be made for access to emergency services.[...]

Q u i c k d i a l V o l u m e C h a n n e l In Use / Battery Low light Comes on when the handset is in use or , if the handset is on standby , to indicate the batter y needs recharging. see page 6 Charging contacts At a glanc e Handset Aerial Does not extend, do not pull out. see page 5 T alk button Activates your Freestyle 70 ready to make or rece[...]

Cont ents 3 At a gl a nc e 1 I nt r oduct io n 4 S ett i n g u p 5 S a f et y i nst ruct io ns 7 Usi n g y o u r F r e est yl e 70 t ele phone 8 H e lp an d a d v i c e 1 2 T ec h nic a l i n for mat i o n 14 Main ten an ce 16 W a ll mo u n t i ng 1 7 I ndex 1 9[...]

Q u i c k d i a l 0 1 2 3 4 Q u i c k d i a l V o l u m e C h a n n e l Intr oduc tion Y our Freestyle 70 is designed for ease of use and made to the high standards set by BT . Thank you for making the right choice. Y ou can expect your Freestyle 70 to provide many years of quality ser vice. Please read the instr uctions carefully before use and ke[...]

Y our Fr eestyle 70 uses a compact aerial which does not pull out. Set ting up Follow these steps to set up your Freestyle 70 r eady for use. ✖ PHONE LINE POWER LINE 1 Handset aerial 3 Plug the mains adaptor cord into the back of the base unit WARNINGS 1 Y our Freestyle 70 should not be fitted in wet or damp conditions, for example in a bathroom.[...]

Y our Fr eestyle 70 works by sending and receiving radio signals between the base unit and the handset. The strength of the signal depends on where you site the base unit and how the aerial is deployed. The higher the base unit is located, the better . An upstairs room is ideal. The following points should be considered: • It should be within eas[...]

Do not use your Freestyle 70 in damp, humid conditions such as bathrooms. Do not expose the equipment to fire or water . Sa fet y instruc tions Use only the power adaptor supplied and the handset batter y pack supplied. There is a slight chance that your phone could be damaged by an electrical stor m. W e r ecommend that you unplug your Freestyle 7[...]

When the handset is not in use you can adjust the ringer volume. The handset ringer volume has 3 settings, HIGH, LOW and OFF. To switch the ringer volume to OFF , press and hold the VOLUME button until you hear a confirmation beep. The Freestyle 70 is pre-set to HIGH. To change the volume on the handset press and release the VOLUME button. On each [...]

PLEASE NOTE Storing a number in the memor y automatically overwrites any previous number stored under the same location code. Stored numbers can include switchboard and network services that use the ✱ and # buttons as well as P AUSE and RECALL functions. PLEASE NOTE If the length of the last number called is more than 32 digits, then the whole nu[...]

Press the QUICKDIAL button. Press the 0-9 location code. Press the QUICKDIAL button again. Y ou hear a confir mation beep. Any existing number stored in the memor y can be over written by entering a new number under the same location code. Simply follow the steps shown in ‘To store a number in the memor y’ , page 9. T o change a stored number T[...]

T o insert a pause T o use the recall button Y ou may need to use the RECALL button if you are connected to a switchboard/PBX (Private Branch Exchange), contact your PBX supplier for fur ther infor mation. The RECALL button, when set to time break recall, is also used for BT Select Ser vices. With some switchboar ds, after dialling the access code [...]

Help If you have any problems using your Fr eestyle 70, this section will give you the most common, easy-to-follow solutions. • No dialling tone. • T elephone will not dial out. • T elephone cannot receive calls. • Beeps six times and drops calls. Telephone not connected to telephone line. Mains disconnected Handset batter y is discharged. [...]

• Callers are faint. • Interference. • Buzzing. • Whooshing. • Echoing. • Tinniness. The base unit telescopic aerial is not extended as high as possible. Y ou are moving out of range. Radio channel inter ference. Radio channel inter ference. The base unit or the handset are too close to electrical equipment or metal obstr uctions. Exten[...]

T echnic al information How many phones can you have? WARNING Th e a p p ar at us is onl y desi g ned t o b e o pe r at ed i n a no rmal o ff ic e or do m est ic e nvi ronm e nt wh er e t he r e lat iv e hu mid it y do es not exc e ed 60%. It s ho ul d not b e use d i n b at hr oo ms or n ea r wat er . Approval for use Y our Fr eestyle 70 is tested[...]

This cordless telephone has been designed to operate on radio frequencies which have been assigned to the exclusive use of cordless telephones. As the use of cordless telephones becomes more widespread, the quality of ser vice obtained from this apparatus may lessen. Channels Base Unit Tx Handset Tx Freq./MHz Fr eq./MHz 1 31.0375 39.9375 2 31.0625 [...]

Installing a handset battery pack and recharging The handset batter y compar tment is located at the back of the handset at the lower end. Replacing the handset on the base unit to recharge over night should keep the Freestyle 70 operative for nor mal use. In time the handset batter y pack will no longer hold a suf ficient charge and should be repl[...]

17 Clip the bracket onto the base unit as shown below . Attach the bracket and base unit by hooking them over the screws protr uding from the wall. W all mounting Y our Fr eestyle 70 can be wall-mounted by using the bracket provided. Y ou can use the bracket as a template to mark where the screws should go into the wall. Drill 2 holes for the screw[...]

102 mm W all mounting t emplate 18[...]

Index 19 A daptor 5 Aerial base 6 handset 5 B ase Unit 2 Batter y care 6, 16 changing 16 charging 5 C alls ending 8 making 8 receiving 8 Channel button 8 Cleaning 16 D ialling mode 11 Director y label 9 E mergency calls 4 Ending a call 8 Environment 14 G uarantee 15 H andset 1 Help and advice 12, 13 Helpline 4 I nductive coupler 8 L ocation 6 M ain[...]

APPROVED for connection to telecommunication systems specified in the instructions for use subject to the conditions set out in them 610064 CE compliant to 89/336/EEC (EMC Directive) & 73/23/EEC (Low V oltage Directive) Offices in Eur ope, North America, Japan and Asia Pacific. The telecommunications ser vices described in this publication are [...]